Preventive Maintenance Program - BIESSE Edge

Service	Cost
Flat rate for 2 days (includes 16 labor hours)	$1000.00 (per visit)
Any day after the 2nd day	$600.00 (per visit)

Additional Cost	Cost
Meals	$35.00/day
Travel hours	Actual (per visit)
Expenses (Airfare, car, lodging, etc.)	Actual (per visit)

This will include a general tune-up the machine, making sure everything is working well, and recommending any parts to be changed (see checklist below).

It will not include any repair/additional training on the machine not listed in the checklist. If repair/additional training is necessary it will require a different purchase order from the customer and the regular rates will apply.

It is Biesse Group America’s discretion (depending on the technician’s schedule and on the spare parts availability) to decide if the repairs can be done at the same time of the preventive maintenance.

The program includes two (2) visits per year. The customer and Biesse Group America will come to an agreement on what time of the year is best for both to schedule preventive maintenance. BIESSE AMERICA reserves the right to schedule the visit within 14 days of the customer’s request.

Once the schedule has been established, Biesse will contact you a month before so that we can schedule a PM maintenance.

Below is a list of items that will be checked on your BIESSE STREAM

Machine & outrigger support level
Calibration of pressure rollers / band and pressure beams
Calibration of end trimming unit
Calibration beveling units
Calibration of profile and flat scrapers
Calibration of oscillating buffing unit and condition of pads
Check condition of feeding track pads and guidance system
Tightness of all mounting hardware for units and motors
Limit switches and sensors: position and tightness
Encoder mounting elements
Gluepot condition
Glue roller lubrication / alignment
Glue pre-melter
Tape feed magazine
End trim blades and all cutter inserts
Setting of all air pressure regulators
Inspection of all safety interlocks and advise customer of any "by-pass" situation
Main air lubricator (one drop every twenty cycles)
Make backup copy of all parameters in NC410D
Setting alarm set point on both thermo regulators
Condition of heating elements and thermocouples